NetBSD/mgp52xx
Avocent MergePoint 5224ĄŁ
<![CDATA[
U-Boot 1.1.2 (Jan 5 2006 - 18:14:39)
Freescale PowerPC
Core: E500, Version: 2.0, (0x80200020)
System: 8541, Version: 1.1, (0x807a0011)
Clocks: CPU: 533 MHz, CCB: 266 MHz, DDR: 133 MHz, LBC: 33 MHz
CPM: 266 Mhz
L1 D-cache 32KB, L1 I-cache 32KB enabled.
Board: OnBoard
PCI1: 32 bit, 33 MHz, sync
PCI2: 32 bit, 33 MHz, sync
PowerA: [ON]
PowerB: [OFF]
I2C: ready
DRAM: Initializing
DDR: 256 MB
Now running in RAM - U-Boot at: 0ff90000
FLASH: 8 MB
L2 cache enabled: 256KB
PCI bus scanning ...
00 10 104c ac55 0607 ff
00 10 104c ac55 0607 ff
00 11 100b 0020 0200 00
In: serial
Out: serial
Err: serial
Board type : 00
Board version_revision : 03
Board model : c0
FPGA version : 54
OnBoard 24-Port, Single PS
Net: MOTO ENET0: PHY is Marvell 88E1111S (1410cc2)
natsemi: NatSemi ns8381[56] @ 0x80002000
MOTO ENET1: PHY is Fake PHY (0)
Marvell 88E6095 switches are starting up ...
Opal #1
Device ID : 0x95
Base Reg Addr : 0x0
No of Ports : 11
CPU Port : 9
Opal #2
Device ID : 0x95
Base Reg Addr : 0x0
No of Ports : 11
CPU Port : 9
Opal #3
Device ID : 0x95
Base Reg Addr : 0x0
No of Ports : 11
CPU Port : 10
QuarterDeck has been started.
Marvell 88E6095 switches set VLANs OK!
Marvell 88E6095 switches startup OK!!
MOTO ENET0, dp83815#0
IDE: Bus 0: OK
Device 0: Model: SMC128BFD6E Firm: CF060926 Ser#: ST0B8365730000055092
Type: Hard Disk
Capacity: 122.5 MB = 0.1 GB (250880 x 512)
Hit any key to stop autoboot: 0
Speed: 100, full duplex
BOOTP broadcast 1
Using MOTO ENET0 device
TFTP from server 10.9.2.2; our IP address is 10.9.2.36
Filename '/boot.mgp'.
Load address: 0x1000000
Loading: #
done
Bytes transferred = 42996 (a7f4 hex)
## Booting image at 01000000 ...
Image Name: Boot
Image Type: PowerPC NetBSD Kernel Image (uncompressed)
Data Size: 42932 Bytes = 41.9 kB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
## Transferring control to NetBSD stage-2 loader (at address 00008000) ...
>> NetBSD/mgp52xx Boot, Revision 1.1
>> (tsubai@sakura, Fri Feb 24 00:42:40 JST 2017)
Using IP address: 10.9.2.36
root addr=10.9.2.2 path=/e/e500
2363140+87996 [154640+138354]=0x29e384
start=0x100000
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013
The NetBSD Foundation, Inc. All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
NetBSD 6.99.23 (MERGEPOINT) #4: Tue Feb 28 07:22:03 JST 2017
tsubai@sakura:/sys/arch/mgp52xx/compile/MERGEPOINT
total memory = 256 MB
avail memory = 247 MB
mainbus0 (root)
cpu0 at mainbus0: 8541E (Revision 11), ID 0 (primary)
cpu0: HID0 0x80804000<EMCP,DOZE,TBEN>
cpu0: HID1 0x44003000<PM1,PC3,ASTME,ABE>
cpu0: 256KB L2 cache
lb0 at mainbus0
com0 at lb0 addr 0x4500 irq 42: ns16550a, working fifo
com0: console
com1 at lb0 addr 0x4600 irq 42: ns16550a, working fifo
tsec0 at lb0 addr 0x24000 irq 29,30: address 00:e0:86:0b:d3:a1
ukphy0 at tsec0 phy 0: OUI 0x000ac2, model 0x000c, rev. 2
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto
tsec1 at lb0 addr 0x25000 irq 35,36: address 00:e0:86:0b:d3:a3
qdphy0 at tsec1 phy 1: QuarterDeck 88E6095
qdphy0: 1000baseT-FDX, auto
qdphy1 at tsec1 phy 2: QuarterDeck 88E6095
qdphy1: 1000baseT-FDX, auto
qdphy2 at tsec1 phy 3: QuarterDeck 88E6095
qdphy2: 1000baseT-FDX, auto
i2c0 at lb0 addr 0x3000 irq 43
pbi0 at lb0: addr 0x8000
pci0 at pbi0 bus 0
pchb0 at pci0 dev 0 function 0: Motorola MPC8541 (rev. 0x11)
cbb0 at pci0 dev 16 function 0: Texas Instruments PCI1520 PCI-CardBus Bridge (rev. 0x01)
cbb1 at pci0 dev 16 function 1: Texas Instruments PCI1520 PCI-CardBus Bridge (rev. 0x01)
sip0 at pci0 dev 17 function 0: NatSemi DP83815 10/100 Ethernet, rev 00
sip0: interrupting at irq 1
sip0: Ethernet address 00:e0:86:0b:d3:a2
nsphyter0 at sip0 phy 0: DP83815 10/100 media interface, rev. 1
nsphyter0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
cbb0: interrupting at irq 2
cardslot0 at cbb0
cardbus0 at cardslot0: bus 1
pcmcia0 at cardslot0
cbb1: interrupting at irq 2
cardslot1 at cbb1
cardbus1 at cardslot1: bus 2
pcmcia1 at cardslot1
obio0 at mainbus0
hwmon0 at obio0: 24-port, 1 PSU (AC)
wdc0 at obio0
atabus0 at wdc0 channel 0
wd0 at atabus0 drive 0: <SMC128BFD6E>
wd0: 122 MB, 980 cyl, 8 head, 32 sec, 512 bytes/sect x 250880 sectors
boot device: tsec0
root on tsec0
nfs_boot: trying DHCP/BOOTP
nfs_boot: DHCP next-server: 10.9.2.2
nfs_boot: my_name=mergepoint
nfs_boot: my_addr=10.9.2.36
nfs_boot: my_mask=255.255.255.0
nfs_boot: gateway=10.9.2.2
root on sakura:/e/e500
root file system type: nfs
Enter pathname of shell or RETURN for /bin/sh:
#
#
#
]]></plaintext></p></body></div>